Foot Assessment
We'll take all the measurements necessary to know the size and volume of your foot, we'll assess your arch height and look at your leg alignment. Then we'll be able to make a selection of the best boot to fit your needs in the most comfortable way.
Atomic Memory Fit Process
This process takes about 30 minutes. We put your Atomic Boots and liners in a special oven and then mold everything to your foot. This allow to customize the fit of both the liner and shell to your specific foot shape.
Liner modification
Another option to create room in the boot is to "punch" the liner. This means we cut the exterior of the liner where needed, replace the thick foam of the liner with a special memory foam that allows for more flexibility and cover it with a non-sticky patch so it doesn't even look like we did any modification.
We can also help reduce the volume of the liner by adding volume reducing padding where needed.
Boot Liner Molding
This process takes about 25 minutes. We heat the liners of your boots (if they are thermomoldable), put them back in the shell while they are hot and then, with your feet in the boots, have you stand up and wait until the liners cool down. We can also put a toe cap on your foot to create more space at the toes or add foam on any problematic areas such as bone spur or bunion in order to prevent pressure on these regions when you're out skiing.
Ski Boot Punch
If molding the liner is not enough, we can heat the shell of your boot where you feel a pressure point and then stretch the boot where needed with our boot press.
*Note that depending of the type of plastic your boots are made of, we'll have to keep your shell between 1 hr and 8 hr per punch.
